Haier WDNS32BW Manuel d'utilisateur télécharger pdf (Page 7)

3. Fill water tank with tap water full to capacity, wait 5 minutes until water settles.

4. Activate the child safety button and press the hot water lever until water starts

to come out, then stop.

5. Plug the dispenser into the electrical socket.

6. Press the hot water switch (back of unit) to the ON position, the switch should

be lit.

A. Press the cold water switch (back of unit) to the ON position, the switch should

be lit.

B. Wait for the hot water to reach temperature in approximately 10 minutes

C. Wait for the cold to reach temperature in other 40 minutes approximately.

7. Press the hot and cold water switch to turn them OFF and unplug the dispenser

from the electrical outlet.

8. Drain the water by pressing hot water button and then cold water button, until

no more water remains (to facilitate this operation, use a large container).

9. Drain any water left in the tanks by opening the drain cap located on the back

side of the dispenser, until the water drains completely. Please remember to

close the drain cap firmly after the drainage.

10. Place a 5 gallon or 3 gallon bottle of water onto the water intake of the

dispenser; allow water to stand for approximate one minute.

11. Push water faucet buttons to insure water flows from both faucets.

12. Plug the dispenser into the electrical socket.

13. Now you are ready to use your water dispenser.

Read carefully and understand all installation instructions before

installing the water dispenser.

1. Remove the cap from the water bottle first. Lift up the water bottle and quickly

place it into the water receptacle. (The water bottle is not included.)

2. DO NOT plug in the water dispenser until you have checked that

water flows out of both faucets when the hot and cold water

release levers are pressed. Never turn on the water dispenser

without water. Doing so may cause the unit to catch fire or

malfunction.

3. Check that water flows out by pressing both the hot and cold water faucets

one at a time.

4. Plug the power cord into an 115volt / 60 Hz outlet.

5. To activate the water heater and cooler, press the hot water and cold water

switches to the ON position, the switches should be lit.

START-UP INSTRUCTIONS

English

1 2 3 4 5 6 7 8 9 10 11 12 ... 37 38

Pas de commentaire

Haier WDNS32BW Manuel d'utilisateur Page 7