Haier WDNS32BW Manuel d'utilisateur télécharger pdf (Page 6)

English

1. Remove all packing materials. This includes the foam base and all adhesive

tape holding the accessories inside and outside.

2. Inspect and remove any remaining packaging, tape and printed material

before turning on the water dispenser.

Note: Allow the water dispenser to stand in an upright position for at least

12 hours before turning on the power.

PROPER LOCATION

• To ensure that your water dispenser works at the maximum efficiency it was

designed for, you should install it in a location where there is proper air

circulation and electrical connections.

• The following are the recommended clearances around the water dispenser.

Sides 2" (50mm)

Back 4" (100mm)

• Do not install your water dispenser in any location that is not properly

insulated or heated because the unit is not designed to operate in room

temperature below 55˚F / 13˚C. The water dispenser is for indoor use only.

Room temperature should not exceed 97° F / 36° C.

Note: Thermostats maintain the hot and cold water temperatures

automatically. On the compressor cooled water coolers the hot water

temperature will be between 190˚-203˚ F/ 88˚- 95˚ C and the cold

water temperature will be between 43˚- 50˚ F/ 6˚-10˚ C.

• Select a suitable location for the unit on a hard even surface away from

direct sunlight and heat sources (e.g., radiators, baseboard heaters, cooking

appliances, etc.).

CAUTION: DO NOT plug in the water dispenser until full bottle is

installed first and water flows from both Hot and Cold

water faucets.

Note: Hot and cold water will not be instantly available as the unit will need

time to heat up and cool down the water.

PREPARATION BEFORE FIRST OPERATION

Before connecting the unit to the power source, Let it stand upright for

approximately 12 hours. This will reduce the possibility of a malfunction in the

cooling system from handling during transportation.

The water dispenser is pre-cleaned at the factory but the reservoir and water

lines should be flushed with fresh water before use as follows:

1. Do NOT plug in the water dispenser.

2. Check and make sure the drain cap on the back of the water dispenser is

firmly closed.

INSTALLATION INSTRUCTIONS

1 2 3 4 5 6 7 8 9 10 11 ... 37 38

Pas de commentaire

Haier WDNS32BW Manuel d'utilisateur Page 6