Haier RBFS21 Manuel d'utilisateur télécharger pdf (Page 21)

English English

Before putting hot foods into the refrigerator, first let cool until they reach room

temperature. Foods stored in the refrigerator should be cleaned and the water

drops patted off after cleaning. Before foods are put into it the refrigerator to

be stored, it is recommended that the foods should be pressurized, so that the

water cannot vaporize, and the fruits and the vegetables can keep fresh, and the

smells of the foods will not mix together. Stored foods can be marked in bags.

Store the foods independently according to the different kinds of foods. Daily

eaten foods should be stored in the front of the shelf. Try avoiding frequent door

openings that reduce food shelf life. When storing food in the fresh food section

make adequate space for air flow circulation. This helps maintain the shelf life of

the food. When you store the foods, you should make sure that the foods stored

in the refrigerator are not too close to the liner to avoid foods freezing on the

back or side walls of the refrigerator. So you should store food making sure that

there is at least some space between the foods stored and the inside walls.

It is suggested for radishes and other root vegetables to trim the leaves before

storage. This keeps nutrients in the root so the leaves do not absorb them. Put

the refrigerated foods into the fresh food area to let them defrost. The low

temperature of the refrigerated foods reduces the formation of bacteria and

extends food life. Some foods like onions, garlic, bananas, and root vegetables

are better stored at room temperature than in the fridge. Melon, pineapples, and

bananas can go directly into the freezer after preparing if storing over longer

period.

• The freezer is suitable for storing food for a long time. The temperature inside

the freezer is low (between -2 and 8 degrees F). It keeps foods fresh for a

long period of time. Frozen foods should be wrapped and marked when

entered to track storage time period.

How to change the freezer light bulb:

The electrical rating of the bulb is: 115V, 60 Hz-40W.

The lamp holder is type E17. (Never use bulbs with power over 40W.)

While changing the light bulb:

• Pull out the power cord plug to cut off the power.

• Lift the light-shield slightly in the direction upward, and then pull it out in the

direction shown.

• Turn the bulb counterclockwise and drop it down, then install a bulb of the

same rating.

• Install the light-shield in the reverse order.

fresH fooD storage tiPs

about tHe freeZer

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 115 116

Pas de commentaire

Haier RBFS21 Manuel d'utilisateur Page 21