Haier ESA412K Manuel d'utilisateur télécharger pdf (Page 85)

INSTALLING THE COUPLER HEAT INSULATION

After checking for gas leaks, insulate by wrapping insulation around the two parts (large and small) of the

indoor unit coupling, using the coupler hest insulation.

After installling the coupler heat insulation, wrap both ends with vinyl tape so that there is no gap.

Secure both ends of the heat insulation material using nylon fasteners.

INSTALLING THE INDOOR UNIT

(1) Lift unit so that suspension bolts pass through suspension fittings at the sides (four places),and slide

the unit back.(See Fig.8.)

FOR HALF-CONCESLED INSTALLATION

In order to check the drainage, be sure to use a level during installation of the

indoor unit. If the installation site of the indoor unit is not level, water leskage

may occur

CAUTION

When installing the indoor unit in a semi-concesled orientation, make sure to reinforce the insulation of

the unit on all sides. Drops of water may fall from the unit if it is not thoroughly insulated.

Glass wool insulate

(10 to 20mm thick )

INDOOR UNIT

(Top view)

Wall

Ceiling pannel

(2) Fasten the indoor unit into place by tightening-up the special "B",blots and the M10 nuts. Make sure

that unit is secure and willl not shift back and forth.

Fig. 9

Ceiling panel

Wall

Ceiling

Fig. 7 Fig. 8

>a__WcU[S^ <[c >a`V[e[a`Wc

-85-

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 258 259

Pas de commentaire

Haier ESA412K Manuel d'utilisateur Page 85