Haier HR-170U Manuel d'utilisateur télécharger pdf (Page 8)

Defrosting

The surface of evaporator ices up when

the refrigerator is working. When the frost

layer is thick as 3mm, the refrigerator must

be defrosted and cleaned. Otherwise, it

may results in lower efficiency and high

energy consumption.

1. Take out foods and ice tray. Keep the

door open.

2. Set the temperature at ‘0’ position.

After defrosting, dry the water tray and

then replace it in the refrigerator. Reset

the temperature regulator to its original

position.

Note: Never use a sharp or pointed item

to defrost or loose the ice tray. Otherwise

it’s likely to damage the surfaces of the

evaporator and result in the leakage of

refrigerant. The manufacturer takes no

responsibility for cost of the reparation

even the appliance is under guarantee.

.7.

Defrosting/Cleaning

Making ice

Fill the 3/4 ice tray with water and then

place it in the lower part of the evaporator.

Set the temperature regulator at ‘7’.

After making ice, reset the temperature

regulator to its original position. Otherwise

foods may get frozen.

To take out the ice cubes

1. Knock the ice tray lightly to loose it.

2. Hold the bottom of the ice tray in warm

water for a while.

3. Twist the ice tray to loose the ice cubes.

Lamp and lamp replacement

Lamp: 240V,15W

Lamp holder: E14 (lamps exceeding 15W

must not be used)

When replacing the lamp:

* Unplug to disconnect the power and

remove the water tray.

* Press the positioning pin of the lamp

with left hand, and release the shade

from the lamp holder by sliding it to the

right side. Turn the lamp anti-clockwise

for removing.

* Replace the water tray.

1 2 3 4 5 6 7 8 9 10

Commentaires sur ces manuels

Pas de commentaire